Why is my Maytag washer keep lid locking?
This washer has sensors that detect the water supply and requires both hoses to have water going to the water valve. If it does not detect both water supply hoses are turned on, the control detects a problem with the water pressure sensor. The lid will lock, and the machine will enter a pump out mode for 8 minutes.
Will a washer work without a lid switch?
NO. The lid lock it to prevent injury to the people near the washer, as without it stopping the machine, the agitator will turn with the lid open. If you will open the top up, you should see the lid switch, and you should see the electric wires attached to it.
How do I reset my lid lock?
2 – Press and hold the “END OF CYCLE / CYCLE SIGNAL” button(s) for 20 seconds and this should reset the washer and clear the flashing light. Important Tip: Never change the washing machine settings once the washer has already started any wash cycle, as this can cause the lid lock light to flash.
How do I reset the lid switch on my washing machine?
If your lid lock light is flashing, you can unplug your washer for 10 minutes and plug it back in to reset the washer and the flashing light. You can also press and hold the ‘End of Cycle’ button for 20 seconds to reset the washer and flashing lid lock light.
Why is my Maytag washer not locking?
Common solutions for: Maytag Washer door or lid won’t lock If the door lock is defective, the washer door will not latch properly. The door lock can fail either mechanically or electrically. Inspect the door lock for damage. If the door lock is damaged or does not latch properly, replace it.
How to reset Maytag washer?
PF. If a power failure occurs when the dryer is running,you will see a power failure error code.
What are the problems with Maytag washers?
16 years’ experience in successful complaint resolution
How to replace timer on Maytag washer?
– Timer will not advance – Will not agitate – See more
What are some common problems with the Maytag Bravos washer?
Clean the Dispenser If the dispenser is removable,fill a sink with hot water and allow the dispenser to soak for at least 30 minutes.