What does it mean when your pool says check cell?
If both the “check salt” and the “inspect cell” lights stay on, it most likely means that no chlorine is being produced at this time and your salt level fell below 2300 ppm. Both lights will also stay on if the controller is set to the wrong turbo cell type, or if the cell is unplugged.
How do I check my cell hours on my Zodiac Tri chlorinator?
– Press and hold the ‘Minute’ switch for 10 seconds until you see the operating hours menu. – Ei will display electrode operating hours (‘CELL HRS’) and total running time (‘CHLOR HRS’). – If Ei electrode has been replaced, press the ‘Hours’ switch to reset cell operating hours.
How do I know if my Zodiac chlorinator is working?
The easiest way to be certain if the chlorinator is working is to make sure the cell is clean by checking the needle or production lights on the chlorinator box. When operating, you should also see bubbles (hypochlorite gas) inside the chamber, producing what looks like cloudy water – that’s chlorine being created!
How do you know if your chlorinator is not working?
Test the water that water has just left the chlorinator – it should have a very high chlorine reading. (Remember that if it is extremely high it may bleach the test tablet so you may have to dilute the water you are testing). If there is no chlorine reading, the chlorinator will not be working.
How do I reset inspect cell?
If the Inspect Cell Light is the only LED light flashing, then you can reset it by simply holding down the diagnostic button for 3 seconds, then release. The Inspect Cell indicator will now reset and will later come back on after another 500 hours of use.
How long does a pool salt cell last?
about five years
This is all possible thanks to your pool’s salt chlorine generator cell. With proper care, a cell will last about five years. Eventually, though, it will need to be replaced. The trick is, it’s not always easy to know when it’s time.
How do you reset the Zodiac chlorinator cell?
Press and hold the MINUTE button until the hours for the power pack and the cell are displayed. Press the HOUR button once to reset the hours for the cell.
How do you reset the check cell on a saltwater pool?
Reset AquaRite Salt Chlorination Inspect Cell Light If the Inspect Cell Light is the only LED light flashing, then you can reset it by simply holding down the diagnostic button for 3 seconds, then release. The Inspect Cell indicator will now reset and will later come back on after another 500 hours of use.
How does a Zodiac chlorinator work?
A Zodiac Chlorinator produces its own chlorine when mildly salted water is passed through the Salt Cell (salt is made up of two elements- sodium and chloride). The chlorine that is produced dissolves instantly in the pool water, going to work immediately to safely sanitize the pool.
How much does a Zodiac Tri chlorinator cost?
We also sell complete reconditioned Zodiac Tri Chlorinators for $440 including GST with 12 months warranty. We’re located at 15 Pound Street, Dutton Park in Brisbane. P. 30677956
How much salt do you put in a Zodiac pool chlorinator?
The Zodiac saltwater chlorinator will require about four thousand parts per million salt in the pool water. You should never let that salt level drop below three thousand parts because it will reduce the life of your electrode. If you do have another brand of chlorinator, it’s best to check the owner’s manual for the recommended salinity level.
How do I change the chlorine in my Zodiac Pool pump?
Replace the cell head and plug assembly. Reset the valves and switches. Turn the pump and your chlorinator back on. Confirm the chlorine output and check that the timer settings have been retained. If the chlorine level is a bit low then the Zodiac saltwater chlorine generator has a boost button that will super chlorinate your pool.