How do I save my USB to Rotalign touch?
touch device – ALI 50.200 upgrade procedure Switch on the touch device. Wait for Home screen to appear. Connect USB memory stick to the touch device USB port. New firmware copied from USB memory stick to the touch device.
How do you read a laser alignment reading?
The bottom line of numbers (to the right of the machine icon with four feet) represents the angularity, offset, front foot and rear foot values in the horizontal plane. Bottom line, look at the angularity and offset in both the horizontal and vertical planes to quickly determine how good the alignment is.
How does laser shaft alignment work?
A laser shaft alignment tool performs measurements by means of two sensors mounted on two connected shafts. Both sensors fire a laser beam and receive the other sensor’s beam simultaneously; a comparison of the beams reveals whether the shafts are aligned and within a specified tolerance.
What is the normal maximum misalignment angle tolerated by a cardan point?
4 to 6 degrees
To ensure sufficient lubrication circulation, which in turn prevents the universal joints from seizing, cardan shafts are normally installed with an angle from 4 to 6 degrees at the universal joints.
How is misalignment measured?
Measurement of Misalignment By measuring your shaft alignment from different points along the horizontal and vertical planes, you can determine exactly how far out of alignment your shafts are and whether you are dealing with angular misalignment or offset (parallel) misalignment or, typically, both.
What is the proper driveline angle?
Most driveline companies recommend operating angles of 3° or less for maximum u-joint life. There should be a minimum of ½° to allow the needles to rotate. The higher the operating angle, the more likely your vehicle will develop a vibration at high driveshaft speeds.
What is the user interface of the rotalign ultra like?
ROTALIGN Ultra has a customer-oriented user interface. It uses easy-to-follow icons and comprehensive onscreen menus and hint texts, that even first-time users are able to operate the computer without difficulty. water resistance. It contains a complete computer with a colour 480 x a menu key.
How do I Turn Off my rotalign touch computer?
The computer is turned off by tapping the On/Off icon [ ] appearing in the home screen. Computer interfaces, built-in camera, and labelling ROTALIGN touch computer has three interfaces housed under the sliding dust cap located at the top of the computer. Edition: (Undefined variable: General.Edition)
What type of laser is used in the rotalign ultra system?
The ROTALIGN Ultra system uses a class II laser beam. Class II lasers standard. It also fulfills British standard BS 4803 (Part 1 to Part 3) and European Industrial Standard IEC 825. The class II laser operates energy per pulse of 0.1 J. No maintenance is necessary to keep this