Where is P0500 located?
Vehicle Speed Sensor Malfunction Diagnostic trouble code P0500 is set when a vehicle’s ECM/PCM detects a loss of signal, or the erratic delivery of a signal, from a vehicle’s speed sensor. In most cases, this speed sensor is seated within the tail shaft of a vehicle’s transmission.
How do I fix error code P0500?
What repairs can fix the P0500 code?
- Vehicle speed sensor drive gear replaced.
- Repair or replacement of the wiring harness.
- Vehicle speed sensor replaced.
- Poor electrical connection resolved.
Where is the speed sensor located on a 2002 Toyota Sienna?
Located on the transmission case, within the rear differential assembly or inside the ABS system, the vehicle speed sensor reads the speed of the wheel rotation on a vehicle while driving.
What is a P0500 engine code?
P0500 code is set when the PCM or engine control module (ECM) detects incorrect speed readings or no signal at all from the vehicle speed sensor (VSS). Other names for this code include: Vehicle Speed Sensor “A” Range/Performance. Vehicle Speed Sensor “A” Intermittent/Erratic/High.
Which wheel is speed sensor A?
The wheel speed sensor is usually located at the front wheel brake disc and mounted on the hub of each wheel, but some cars are different. Some rear-wheel-driven vehicles have only an electromagnetic induction speed sensor in the main reducer or gearbox.
Will a code P0500 cause the transmission to not move forward?
Below are the common symptoms you may face if your OBD-II scan tool is showing the P0500 code: Malfunctioning speedometer. Erratic shifting with an automatic transmission. Inactive or erratic ABS performance.
How much does it cost to replace a VSS sensor?
The average cost for vehicle speed sensor replacement is between $275 and $318. Labor costs are estimated between $116 and $146 while parts are priced between $159 and $172. This range does not include taxes and fees, and does not factor in your specific vehicle or unique location.
What does diagnostic code P0500 mean?
Vehicle Speed Sensor (VSS) Malfunction
What Does the P0500 Code Mean? Diagnostic trouble code (DTC) P0500 stands for “Vehicle Speed Sensor (VSS) Malfunction.” This code is set when the PCM or engine control module (ECM) detects incorrect speed readings or no signal at all from the vehicle speed sensor (VSS).
Do you need to reset ABS light after changing sensor?
If the ABS wheel speed sensor was faulty, once the new hub/sensor is installed, and you drive the vehicle, the warning lights should go out. To determine what is going on, you can manually erase the trouble codes using an appropriate scan tool and if the warning lights stay off, then the problem is resolved.
What happens if I disconnect the speed sensor?
If it’s the wheel speed sensors (like for the ABS) the car will run but the ABS system won’t be able to do its job. If we’re talking about any engine sensors, the engine MIGHT still run, but it will likely run poorly or throw a check engine light.
What problems can a bad wheel speed sensor cause?
A bad wheel speed sensor can result in a loss of traction control and stability. This, in turn, can trigger the ABS system to disable the traction control and stability systems. This consistent malfunctioning can result in limp mode.
Can you clean a wheel speed sensor?
With the sensor free, take your rag and wipe the sensor until it’s clean. I prefer not to use any chemicals on the sensor to avoid potential problems. If, however, the sensor is really grungy, use a mild soapy solution and rinse well.