What does Ford code P1000 mean?
OBD-II Trouble Code P1000 Description. On Board Diagnostic System Readiness Test Not Complete. In the majority of cases, diagnostic trouble code P1000 indicates that a vehicle’s onboard diagnostic system has been unable to complete its standard list of readiness checks.
What is OBD system readiness test?
OBD2 Readiness Monitors are simple yet powerful self check routines. They provide insight to the car’s self-diagnostics. This tutorial will explain in detail what the readiness monitors are. The purpose of readiness monitors is to self-test the car’s emission control systems.
What is manufacturer controlled DTC?
Manufacturer Controlled DTC is a fault type drive system in the section of air supply system and failure of fuel.
How do I fix error code P1000?
Many times, this error code will disappear on its own after you drive the car for a while. In most cases, there’s no need to diagnose or repair your car when you see the error code P1000.
How do I complete a Drive Cycle?
15 minutes of steady driving on an expressway/highway followed by 20 minutes of stop-and-go driving with at least four 30-second idle periods. Allow the vehicle to sit for at least eight hours without starting the engine. Then, start the engine and complete the above driving cycle.
How do you complete a Ford drive cycle?
Stop the vehicle. Idle the vehicle in Drive for 1 minute. Drive at 25 mph and drive for 15 minutes at speeds between 15-35 mph. Within this time, stop at least 5 times, and have at least 3 periods of steady speed for 90 second durations.
How can I fix a P1000 problem and where should I start?
How can I fix a P1000 problem and where should I start? In order to clear a P1000 trouble code the vehicle must be driven through a Drive Cycle until all monitors are completed or in ready status.
What can cause a P1000 code?
More About P1000 Error Codes This error code essentially means that your car’s ECC has not completed its emission systems test. The computer on your vehicle must complete several self-tests known as Readiness Monitors. The display of a P1000 code means that this testing has not been finalized.
How long does it take for a car to go through a drive cycle?
Preparation for it will take eight hours but, all in all, a basic drive cycle test should take around 30 minutes to complete, with about 20 minutes of actual driving. Understanding your vehicle’s overall health can help you ensure it drives smooth and lasts long.