What year is a John Deere 1010?
The John Deere 1010 was built from 1960 through 1965, when it was replaced by the John Deere 1020. It was built in Dubuque, Iowa, USA, and featured a 36 hp (27 kW) John Deere engine.
How many horsepower is a 1010 John Deere?
John Deere 1010
| John Deere 1010 Power | |
|---|---|
| Drawbar (claimed): | 30 hp 22.4 kW |
| PTO (claimed): | 36.13 hp 26.9 kW |
| Drawbar (tested): | 30.00 hp 22.4 kW |
| PTO (tested): | 36.13 hp 26.9 kW |
What is the firing order for a John Deere 1010?
There can be only two combinations on a 4 cylinder engine.It has to be 1-3-4-2 as are most engines or 1-2-4-3.
How much is a John Deere 1010?
$2,750. 1010RS John Deere Diesel.
How much oil does a John Deere 1010 hold?
John Deere 1010 Wheel Engine
| Engine Detail | |
|---|---|
| John Deere | |
| Starter volts | 12 |
| Oil capacity | 5 qts 4.7 L |
| Coolant capacity | 11 qts 10.4 L |
How wide is a John Deere 1010?
John Deere 1010 Dimensions
| Dimensions | |
|---|---|
| RU Wheelbase: | 82.5 inches 209 cm |
| 1010RU Height (exhaust): | 72.3 inches 183 cm |
| 1010RU Front tread: | 50 to 80 inches 127 to 203 cm |
| 1010RU Rear tread: | 56 to 89 inches 142 to 226 cm |
How much does a John Deere 1010 dozer weight?
Open operator station. FAQ: How to read a serial number table. http://techpubs.deere.com/ – Official operator manuals for purchase or download from Deere….John Deere 1010 Crawler.
| John Deere 1010 Crawler Engines | |
|---|---|
| John Deere 1.9L 4-cyl gasoline | |
| John Deere 2.4L 4-cyl diesel | |
| Fuel tank | 12 gal 45.4 L |
| Engine details … |
How much does a John Deere 440 Dozer weight?
John Deere 440C
| Dimensions & Tracks | |
|---|---|
| Wheelbase | 69 inches 175 cm |
| Weight | 6919 to 7281 pounds |
| Tracks | |
| Full dimensions and tracks … |
How do you test a John Deere ignition module?
Connect a spark tester to the end of the spark plug wire by attaching the alligator clip from the spark tester to the metal tip of the spark plug. Wear gloves in case a spark jumps while you are completing this step. Set the gap to 4.2mm on top of the spark tester by using the adjustment knob.