How do I update my ap9630 firmware?

Posted on by Mary Andersen

How do I update my ap9630 firmware?

More videos on YouTube

  1. Select the “UPS Network Management Card 2” link.
  2. Scroll down to the product documentation tabs.
  3. Click the Software and Firmware tab.
  4. Find the firmware file.
  5. Verify that you have located firmware appropriate for the host UPS family.
  6. Click the “Download” Link.
  7. Then Select the “Download Now” button.

How does APC connect to Internet?

Connect to the UPS/device serial port using the correct APC configuration cable….9600 bps, 8 data bits, no parity, 1 stop bit, and no flow control.

  1. Apply the port settings to establish the connection.
  2. Press enter 3-5 times to display the username prompt.
  3. Use the default username and password of “apc”.

How do I reset ap9630 APC?

Hold the reset button for 5-7 seconds. Resets only the password. Hold the reset button for 20 seconds. This will restore the card to factory default settings including switching back to DHCP mode.

How do I upgrade my APC NMC firmware?

APC UPS – Upgrading the Firmware

  1. Access the APC website support area and download the lastest version of firmware to your Network Management Interface.
  2. Extract and start the firmware upgrade utility.
  3. Enter the IP address of your UPS, enter the APC username and it’s password.

How do I configure ap9630?

By default, the APC AP9630 NMC (Network Management Card) does not have an IP address assigned. The easiest way to configure an IP address is to log into the UPS’s NMC over a serial port….Serial Access.

Type Device path
USB-Connected port 1 /dev/ttyUSB0
USB-Connected port 2 /dev/ttyUSB1

How do I reset my apc battery backup?

To do this, follow the below procedure;

  1. Disconnect any attached load.
  2. Unplug the UPS from the wall socket.
  3. Disconnect the UPS’ internal battery.
  4. Push and hold the “”On”” button on the UPS for 5 seconds.
  5. Reconnect internal battery.
  6. Plug UPS in to known good power source.
  7. Turn UPS on.

Is the AP9630 hot swappable?

Underside of AP9630 Network Management Card 2 If your SmartSlot accessory looks similar or has two or more pins that are longer than the others, this identifies the SmartSlot accessory as hot swappable.

How do I find my APC UPS IP address?

On the LCD menu, access the About menu. On the About menu, select the SmartSlot Card option. Locate and access the IP address option. In our example, the LCD menu shows the APC UPS IP address 10.10.