How do you open a Stanley Bostitch b310hds stapler?
Hold the top of the stapler in place with your non-dominant hand. Never place your hand under the stapler. Use your dominant hand to push in on the back and then pull it up and out. Detach it completely, and the magazine where the staples are placed should be removed as well.
What causes a staple gun not to work?
When any important part is broken or worn out, the tool simply won’t work. Before you start using a staple gun, check to ensure the spring, hammer, and rail are correctly assembled and undamaged. Make sure you are using staples of the correct size and type for the tool.
How do you take apart a one touch stapler?
Open the base away from the body so the base and the body of the stapler are in a straight line; you should be able to open up the stapler a full 180 degrees. Identify the tab at the end of the magazine pusher located near the hinge – in most models, the tab is black. Pull the tab and slide out the magazine.
How do you fix a staple gun jam?
Clear the jam with needle-nose pliers. Check out the top of the stapler where the staples are discharged. Use the pliers to pinch the staple and pull towards you, pulling the staple out of the stapler’s nose. After that, reassemble the staple gun by putting the magazine back in and screwing in the screw.
How many springs are in a stapler?
2 Leaf springs, which resemble a diving board, are typically made by either bending or rolling (slightly curling) a thin piece of steel and then carefully heating it to a temperature that will cause internal stresses.
What is the function of a spring in a stapler?
Springs, springs, springs The aim is to make changes in the characteristics of the metal – to give the metal elasticity. Once it has been heat treated, it can be pulled apart and pressed together – and always return to its original state. This is what is used to hold the staples to one end of the magazine.