What is the standard spout reach for a kitchen faucet?
Find out the length or reach of your faucet’s spout (also called the projection). The distance between the faucet body (where the water enters the faucet) and the areator is usually 8 to 10 inches for a kitchen faucet. However some oversized faucets have a reach of 11 to 16 inch.
How do I choose spout reach?
To find the ideal spout reach, measure from the center mounting hole forward to the center of your sink. This will ensure that if your installation holes are set further beyond the sink edge, it will still reach the middle of the sink and make washing the dishes more comfortable.
What is a high-arc spout?
A high-arc faucet, sometimes called a gooseneck faucet, stands taller than low-profile or low-arc faucets. While there’s not a set size guideline for “high” arc designation, this type of faucet usually stands 8 to 10 inches from the top of the counter to the highest point of the faucet, according to Moen.
How far should faucet reach sink?
The standard reach for many sink faucets is an average measurement of 5.5 inches deep.
How do you measure a faucet spout?
Measure from the tallest portion of the faucet spout to the bottom, where it joins with the counter. Ensure the tape is straight up and down. In addition, measure the distance from the spout neck to the end of the spout straight across.
How is spout reach for a faucet measured?
Spout reach is measured from the center of the spout base horizontally out to the water stream. Spout height is measured from the sink/countertop surface vertically up to the highest point. Refer to the specification sheet for your faucet for specific measurements.
How is faucet spout reach measured?
What is spout clearance?
Clearance. For a faucet that swivels and for easy cleaning, measure the distance between the faucet hole and the backsplash to ensure that the faucet has enough space to move freely (without the spout or handle hitting the wall).
What is spout reach?
Spout reach is measured from the center of the spout base horizontally out to the water stream. Spout height is measured from the sink/countertop surface vertically up to the highest point.
How far back should a kitchen faucet be?
It’s typically 4 inches between handles or between the spout and the handle for bathroom faucets and 8 inches for kitchen fixtures.
How far should tap extend into basin?
For ease of use and less splashing, the best faucet extends seven inches into the bathroom sink. Faucets should always have a spout reach of at least five and a half inches. Seven inches, however, gives ample room so that you aren’t bumping against the back of the sink when you wash your hands.
How far should sink faucets extend?
How far should a faucet extend into a sink?
What is spout clearance in a faucet?
What is spout projection?
Projection – This is the measurement of the faucet spout’s reach into the sink and from side to side as it swivels (see red notations). This is calculated from the center of the stem to the center of the spout.
How do you measure kitchen faucet spout reach?
Measuring Spout Height and Reach Spout reach is measured from the center of the spout base horizontally out to the water stream. Spout height is measured from the sink/countertop surface vertically up to the highest point.
What is spout reach on a faucet?
What is an 8 inch faucet spread?
On an 8″ spread there will be 8″ from the center of the hot faucet to the center of the cold faucet. Like this: A 4″ or mini spread will be quite close together and make it difficult to clean around the handles and spout.