How do I control my air compressor?
Start/Stop. Start/stop is the simplest control available and can be applied to either reciprocating or rotary screw compressors. The motor driving the compressor is turned on or off in response to the discharge pressure of the machine. Typically, a simple pressure switch provides the motor start/stop signal.
What are the controlling factors for compressor?
What influences air compressor energy efficiency? Such factors include type, model, size, motor power rating, system design, control mechanisms, uses and maintenance schedule.
What is the most common type of compressor control?
Rotary Screw Compressors. Rotary screw compressors have gained popularity and market share (compared to reciprocating compressors) since the 1980s. These units are most commonly used in sizes ranging from about 5 to 900 HP. The most common type of rotary compressor is the helical twin, screw compressor.
What is compressor performance controller?
Performance control adjusts the compressor loading via the motor’s variable frequency drive (VFD), the turbine’s governor, inlet guide vanes (IGV), or suction throttling valve to meet process demands for compression, as measured by: Suction pressure.
How do I get more PSI from my air compressor?
- Use a screwdriver to remove the screws from the top of the pressure limiter switch cover.
- Locate the two limiter switch screws.
- Turn the compressor on and adjust the screw until the compressor runs until the gauge reaches the desired pressure.
- Leave the cover off.
How do I increase the pressure on my air compressor?
What is compressor control system?
A compressor control system allows you to monitor and change your compressed air machine. For example, some compressor control systems let you set automatic load and unload when it reaches a pre-set amount of pressure. Others give you the option to adjust the speed of your compressor motor.
What is anti-surge control valve?
The control valve protecting the compressor is the anti-surge control valve. This control valve is closed when the compressor operates normally and opens quickly to connect the inlet and outlet of the compressor when surge conditions almost occur.