What is a 8 to 1 line multiplexer?
An 8-to-1 multiplexer consists of eight data inputs D0 through D7, three input select lines S0 through S2 and a single output line Y. Depending on the select lines combinations, multiplexer selects the inputs.
How many selected lines would be required for an 8 line to 1 line multiplexer?
3
An 8 × 1 multiplexer selects one of the 8 inputs and presents it to the output, i.e. So the number of select lines will be 3.
What devices use multiplexers?
Computers
- Computers.
- All-in-One Desktops.
How many and gates are required for a 1 to 8 multiplexer?
8 AND gates
For a 1 to 8 multiplexer a total of 8 AND gates are required.
How many and or and XOR gates are required?
Explanation: there are 2 and, 1 or and 2 exor gates required for the configuration of full adder, provided using half adder.
How many and Gates & select lines are required for a 1 to 8 multiplexer?
How many AND gates are required for a 1-to-8 multiplexer? Explanation: The number of AND gates required will be equal to the number of outputs in a demultiplexer, which are 8.
How many gates are in a MUX?
Multiplexer Input Line Selection Then the implementation of the Boolean expression above using individual logic gates would require the use of seven individual gates consisting of AND, OR and NOT gates as shown.
How many control lines do an 8 to 1 multiplexer have?
How many data lines are needed for 8 inputs?
three data select lines
For selecting eight inputs, there are three data select lines that must be used. The multiplexer requires the data select lines.
How many or gates are required for 8 to 1 multiplexer?
For a 1 to 8 multiplexer a total of 8 AND gates are required.
What is an 8×1 multiplexer?
The following figure is the 8×1 multiplexer. Now this 8×1 MUX is a high-level multiplexer. For simplicity, the 8×1 mux can also be implemented using 2×1 or 4×1 multiplexers. You can observe that the input signals are D0, D1, D2, D3, D4, D5, D6, D7, S0, S1, S2 and the output signal is out.
What is a 3 bit multiplexer?
This multiplexer is a 3 bit (8 in) selector. The binary number you select, the 0 to 7 (8 values) input you choose to bring at the output. Have fun! Sel. in 000 ~ 0 001 ~ 1 010 ~ 2 011 ~ 3 100 ~ 4 101 ~ 5 110 ~ 6 111 ~ 7
What is a multiplexer and how does it work?
A multiplexer is a data selector which selects a particular input data line and produce that in the output section. It is implemented using combinational circuits and is very commonly used in digital systems.
How many input and output lines are there in a multiplexer?
Data Processing Circuits Unit 2 Multiplexers Multiplex Means Many Into One A Multiplexer Is Circuit With Inputs But Only Output By Applying Ppt Design An 8 To 1 Line Multiplexer Using A 3 Decoder And Eight 2 Input Gate Or Quora